Hydrogen Compressor, 60 HP, 70-140 psi inlet - 6000 psi discharge at 50 scfm

Used Hydro-Pac LX-Series High-Pressure Hydrogen Compressor, Model C06-60-70/140LX, built for industrial hydrogen compression and compatible with other inert gases. Accepts inlet pressure of 70 to 140 PSIG and delivers maximum discharge pressure of 6,000 PSIG with flow capacity of 33.6 kg/hr at 80°F, up to 46 SCFM at minimum pressure, and up to 82 SCFM at 3,000 PSIG discharge. Powered by a 60 HP NEMA Class 1 Division 2 TEFC motor. Sold as-is in good used condition. Inlet Pressure: 70 to 140 PSIG (4.8 to 9.7 Bar) Maximum Discharge Pressure: 6,000 PSIG (414 Bar) Flow Rate / Capacity: 33.6 kg/hr at 80°F, up to 46 SCFM at minimum pressure, and up to 82 SCFM at 3,000 PSIG discharge pressure. Motor: 60 HP NEMA Class 1 Division 2 TEFC Power Requirements: 460V, 3-Phase, 60Hz Control Power: 120V, 1-Phase, 60Hz Ambient Operating Temperature: 50–100°F Cooling Requirement: 15 GPM water at 60–80°F This unit includes an explosion-proof reciprocating circuit, gas aftercooler, and explosion-proof oil reservoir heater. Controls and Safety: On/off pressure control allows the operator to set start/stop discharge pressure points. Electrical: Full-voltage 460V, 3-phase motor starter, NEMA 4 enclosure with start/stop push buttons, control power transformer, and hour meter. Instrumentation: Controller with dual set points and discharge pressure transducer. Safety Compliance: Electrical enclosure housing the controller and motor starter must be installed in a non-hazardous environment, and intrinsically safe barriers are included. This unit is sold as-is and is in good used condition

Inspection Pre-purchase inspections are welcome during normal business hours by appointment arranged in advance. We can provide complimentary transportation from DFW Airport and back if you would like to send someone to see the equipment in person. We can also walk through the item over a video call for domestic or international buyers. We are on US Central Time. Shipping and loading The equipment is located at our yard south of Dallas, Texas. We can assist with shipping arrangements. Loading is provided at no charge for equipment under 15,000 lb when scheduled in advance. Equipment over 15,000 lb requires a crane, which is arranged and paid for by the buyer. Payment Payment in full is required FOB our yard in South Dallas. A verifiable cashier's check is accepted for collection in person. For release to a third-party shipper we require a wire transfer cleared in our account before the equipment leaves the yard.